1995 Buick LeSabre Owner's Manual - Page 115

If the display is flashing afterthe system is started, you should see your dealer for service. Sun and temperature sensors automatically adjustair temperature to maintain your temperature setting. The system may supply cooler airto the side towards the sun. Be careful not to put anything over the sensors on top of the dash. The system may not respond correctly. Pushing the FAN, AIR FLOW or FRONT buttons will override this delay, turn off the AUTO setting, and change the Fan speed. TEMP: To adjust the temperature you want maintained inside the car, push the TEMP button. If you want warmer air push the red arrow.If you want cooler air push the blue arrow. Note the degree selection in the display. You can choose between 60°F (16°C) for maximum cooling, to 90°F (33°C) for maximum heating. The system does not cool or warm faster with 60°F (16°C) or 90°F (33°C) selected, so it is not necessary to choose the extreme temperature to get system to heat or cool the at the maximum. The system does it automatically. AUTO: Press the AUTO button when you want the system to adjust automatically to changes in temperature. When the system is set for automatic, air will come from the floor, middle, or windshield outlets. Fan speed will vary as the system gets to and maintains the temperature setting you have selected. To find your comfort zone, start with 75" AUTO, give the car about20 minutes to stabilize, and adjust the temperature setting if necessary. The display will show the set temperature and fan speed forfew seconds and a then display the outside temperature. If you want to check and see what automatic temperature settinghas been chosen, press the AUTO button. In cold weather the system will delay turning on the fan, to avoid blowing cold air. The length of the delay depends on engine coolant temperature, outside temperature, and time since the engine was last started. FAN: The speed of the blower fan is controlled automatically if you have the system set for AUTO. Pressing the FAN button will display and hold the current blower fan setting. If you want the blower fan to run at a lower speed, push the bottom of the FAN button. The fan speed will decrease with every push of the button until the lowest speed is reached. If you want to increase the fan speed, push the top of the fan button. Notice the fan indicators in the display. 3-3