1995 Buick Park Avenue Owner's Manual - Page 66

2. Find the 16-pin diagnostic connector above the accelerator pedal. press 4. Keeping the program terminal gro~~nded, the UNLOCK button on the first transmitter. The door locks will lock and unlock again to indicate the transmitter is now matched. If there is 110 response. check the transmitter batteries. If you d o not want to match a second transmitter. proceed to Step 6. a~n S . Still keeping the ~ ~ " o g rterminal grounded, repeat Step 4 with the second transmitter. If you disconnect the ground wire before completing this step, o n l y the first transmitter is matched. If you make a mistake, disconnect the jumper wire and start over a t Step 3. BLK ASSEMBLY LINE DIAGNOSTIC LINK (ALDL) CONNECTOR 6. Remove the jumper wire. (Note: The system will not operate if the jumper wire is still connected.) 7 . Test the operation of both transmitters with the vehicle. 3. Connect a fuse jumper wire with alligator clips at both ends from the program circuit (Terminal 8) t o the g r o ~ ~ n d circuit (Terminal 4). Grounding the program terminal erases the system memc>ry and causes the doors to lock and unlock once. This means the system is ready to be matched to the transmitter. If the lock control does not work as it should. see your Buick dealer. 2-8 -