1997 Buick Skylark Owner's Manual - Page 94

Flash-To-Pass Feature (Except Canada) This feature lets you use your high-beam headlamps to signal a driver front of you that you want to pass. in It works even if your headlamps are off. To use it, pull the turn signal/multiifunction beam lever toward you a little (but notso far that you hear a click). If headlamps 'are your high-beam headlamps will off, t r on. They'll stay on as longas you hold the lever un there. Release the lever to turn them off. If your headlamps are on, but on low beam, system the works normally.Just pull the lever untilit clicks. Your headlamps will shift to high beam and stay there. To return to low beam,just pull thelever toward you until it clicks again. You control the windshield wipers by rotating the outer portion of the switch. For a single wiping cycle, move the band toward you. Hold it down until the wipers start, then let go. The wipers will stop after one cycle. you want more If cycles, hold the lever down MIST longer. to For steady wiping at low speed, move band to the the LO position. For high-speed wiping, move band the further up.To stop the wipers, move the bandOFF. to