2002 Buick Park Avenue Owner's Manual - Page 106

1. Move the cruise control switch to ON. Remember, if you hold the switch at R/A, the vehicle will accelerate until you release the switch or apply the brake. So unless you want to go faster, don't hold the switch at R/A. Increasing Speed While Using Cruise Control There are two ways to go to a higher speed: D Use the accelerator pedal to go to a higher speed. 2. Get up to the speed you want. 3. Push in the SET button at the end of the turn signal lever and release it. The CRUISE light on the instrument panel cluster will come on. 4. Take your foot off the accelerator pedal. Resuming a Set Speed Setting the cruise control at a desired speed and then applying the brake will end the cruise control function. Once you're going about 25 mph (40 km/h) or more, you can move the cruise control switch from ON to R/A (Resume/Accelerate) briefly to reset. This returns you to your desired preset speed. Push the button at the end of the lever, then release the button and the accelerator pedal. You'll now cruise at the higher speed. there until you reach a desired speed and then release the switch. To increase your speed in very small amounts, briefly move the switch to R/A then release it. D Move the cruise switch from ON to R/A. Hold it Each time you do this, your vehicle will go about 1 mph (1.6 km/h) faster. The accelerate feature will only work after you have set the cruise control speed by pushing the SET button. 2-43