2005 Buick LeSabre Owner's Manual - Page 132

2. Adjust the seat to your driving position. Press the image height adjuster switch to raise the image as far as possible. 3. Now press the image height adjuster switch to position the image as low as possible, while still keeping it in full view. 4. Slide the dimmer lever downward until the HUD image is no brighter than necessary. To turn the HUD display off, slide the dimmer lever to OFF. If the sun comes out and the sky becomes cloudy, you may need to adjust the HUD brightness using the dimmer lever. Polarized sunglasses could make the HUD image harder to see. To change the display from English to metric units, push the ENG/MET button located to the left of the steering column. Clean the inside of the windshield as necessary to remove any dirt or film that reduces the sharpness or clarity of the HUD image. To clean the HUD lens, spray household glass cleaner on a soft, clean cloth. Gently wipe and dry the HUD lens. Do not spray cleaner directly on the lens to avoid cleaner leaking inside the unit. If the ignition is in RUN and you cannot see the HUD image, check to see if: Something is covering the HUD unit. The HUD dimmer lever is adjusted properly. The HUD image is adjusted to the proper height. A fuse is blown. See Fuses and Circuit Breakers on page 5-88. Keep in mind that your windshield is part of the HUD system. If you ever have your windshield replaced, be sure to get one that is designed for HUD or your HUD image may look blurred or out of focus. Accessory Power Outlets The accessory power outlets can be used to plug in electrical equipment such as a cellular telephone or CB radio. Your vehicle may have up to three power outlets depending on the type of front seat you have. If your vehicle has front bucket seats with a center console, you will find two outlets inside the rear storage compartment. An extra power outlet can be found in the ashtray. 3-22