2005 Buick LeSabre Owner's Manual - Page 160

If you see the CHECK TIRE PRESSURE message, you should stop as soon as you can and check all your tires for damage. If a tire is flat, see If a Tire Goes Flat on page 5-69. Also check the tire pressure in all four tires as soon as you can. See Inflation - Tire Pressure on page 5-60 and Check Tire Pressure System on page 5-62. There are times when you will have to reset (calibrate) the Check Tire Pressure System. See Check Tire Pressure System on page 5-62. RESET: This button, used along with other buttons, will reset system functions. ENG/MET (English/Metric): Use this button to change the display between English and metric units. DIC messages can be displayed in one of three languages: English, French or Spanish. The language of the display is set by pressing both the FUEL INFO and RESET buttons for five seconds. As the buttons are held, each language will be displayed for three seconds. Release the FUEL INFO and RESET buttons when the desired language is displayed. All DIC messages will now be in the selected language. Language selection can also be done through the DIC Personal Choice Programming. See "Language Selection" under DIC Vehicle Personalization on page 3-51. DIC Warnings and Messages Other messages or warnings may appear in the DIC display. For Canadian drivers, in addition to the DIC message your DIC will display EXP with a number after it which reflects the following messages: EXP (Export ID) Warning Message 20 TURN SIGNAL STILL ON? 24 TRUNK AJAR 25 WINDSHIELD WASHER FLUID LOW 27 BATTERY SAVER ACTIVE 36 ENGINE OIL LOW - CHECK LEVEL 40 THEFT ATTEMPT DETECTED 54 SERVICE STABILITY SYSTEM 55 STABILITY SYSTEM ACTIVE 61 GAS CAP LOOSE - CHECK CAP 81 CHANGE ENGINE OIL SOON 91 TRACTION CONTROL SYSTEM ACTIVE 102 CHECK CHARGE SYSTEM 139 DOOR AJAR 144 CHECK TIRE PRESSURES The EXP codes are used to make translation from English to other languages easier. Pressing any of the DIC control buttons will remove the messages or warnings from the DIC display. 3-50