2011 Buick Enclave Owner's Manual - Page 126

5-8 Instruments and Controls Setting the Analog Clock The analog clock is located on the instrument panel above the radio. The clock is not connected with any other vehicle system and runs by itself. To adjust the time: 1. Push and hold the button located directly above the clock to advance the clock hands. Holding the button down causes the clock to advance faster. 2. Push and release the button to increase the time by one minute increments. 3. Press the pushbutton located under the currently displayed status of either ON or OFF to toggle the radio clock display on or off. The ON display indicates the radio clock display is disabled and the OFF display indicates the radio clock display is enabled. . 3. Press the set/reset button to start the compass calibration. 4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu. Clock The vehicle has an analog clock and a digital radio clock. The digital radio clock can be enabled or disabled. If the radio clock display is turned on, the screen displays Radio Clock ON for 10 seconds, then returns to the original clock display menu. If the radio clock display is turned off, the screen displays Radio Clock OFF for 10 seconds. The menus for clock and date settings are removed, and ON displays as a current status indicating that the clock display can be turned on. Enabling/Disabling the Digital Radio Clock To enable or disable the radio clock display: 1. Press H until the clock and date setting menus appear. 2. Press the pushbutton located under the forward arrow label until the menu for default clock and date settings appear. .