2011 Buick Enclave Owner's Manual - Page 270

9-32 Driving and Operating Cruise Control With cruise control, a speed of about 40 km/h (25 mph) or more can be maintained without keeping your foot on the accelerator. Cruise control does not work at speeds below about 40 km/h (25 mph). When the brakes are applied, the cruise control is disengaged. [ (Cancel): Press to disengage cruise control without erasing the set speed from memory. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. The cruise control light on the instrument panel cluster comes on after the cruise control has been set to the desired speed. 1. Press the I button to turn the cruise control system on. 2. Get up to the speed desired. 3. Press and release the SET- button located on the steering wheel. 4. Take your foot off the accelerator. { WARNING Cruise control can be dangerous where you cannot drive safely at a steady speed. So, do not use the cruise control on winding roads or in heavy traffic. Cruise control can be dangerous on slippery roads. On such roads, fast changes in tire traction can cause excessive wheel slip, and you could lose control. Do not use cruise control on slippery roads. The cruise control buttons are located on left side of the steering wheel. Press to turn cruise control on and off. The indicator comes on when cruise control is on. + RES (Resume/Accelerate): Press briefly to make the vehicle resume to a previously set speed, or press and hold to accelerate. SET- : Press to set the speed and activate cruise control or to make the vehicle decelerate. T (On/Off):