2014 Buick Regal Owner Manual - Page 36

2-6 Keys, Doors, and Windows 3. Wait 10 minutes until the security light turns off. 4. Turn the ignition to LOCK/OFF. 5. Repeat Steps 2-4 two more times. After the third time, turn to ON/RUN; the key is learned and all previously known keys will no longer work with the vehicle. Remaining keys can be learned by following the procedure in "Programming with a Recognized Transmitter (Key Vehicles Only)." Programming with a Recognized Transmitter (Keyless Access Vehicles Only) A new transmitter can be programmed to the vehicle when there is one recognized transmitter. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be with you. 4. Repeat Steps 1-3 if additional keys are to be programmed. If a key is lost or damaged, see your dealer to have a new key made. Programming without a Recognized Transmitter (Key Vehicles Only) Program a new key to the vehicle when a recognized key is not available. Canadian regulations require that owners see their dealer. If there are no currently recognized keys available, follow this procedure to program the first key. This procedure will take approximately 30 minutes to complete for the first key. The vehicle must be off and all of the keys you wish to program must be with you. 1. Insert the new vehicle key into the ignition. 2. Turn to ON/RUN. The security light will come on. 1. Place the recognized transmitter(s) in the cupholder. The cupholder liner will need to be pulled out to access the transmitter pocket. 2. Insert the vehicle key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5.