2015 Buick Encore Owner Manual - Page 190

Driving and Operating 9-31 1 (On/Off): Press to turn the cruise control system on or off. A white indicator comes in the instrument cluster when cruise is turned on. RES/+ (Resume/Accel): If there is a set speed in memory, move the thumbwheel up briefly to resume to that speed or hold upward to accelerate. If cruise control is already active, use to increase vehicle speed. SET/− (Set/Coast): Move the thumbwheel down briefly to set the speed and activate cruise control. If cruise control is already active, use to decrease speed. To set a speed: 1. Press 1 to turn cruise control on. 2. Get up to the speed desired. 3. Move the thumbwheel down toward SET/− and release it. 4. Remove your foot from the accelerator. The cruise control indicator on the instrument cluster turns green after cruise control has been set to the desired speed. See Instrument Cluster on page 5-8. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied or * is pressed, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed is about 40 km/h (25 mph) or greater, move the thumbwheel up toward RES/+ briefly. The vehicle returns to the previously set speed. Increasing Speed While Using Cruise Control If the cruise control system is already activated: . Move the thumbwheel up toward RES/+ and hold it until the desired speed is reached, then release it. To increase vehicle speed in small increments, move the thumbwheel up toward RES/+ briefly. For each press, the vehicle goes about 1.6 km/h (1 mph) faster. . * (Cancel): Press to disengage cruise control without erasing the set speed from memory. Setting Cruise Control The speedometer reading can be displayed in either English or metric units. See Driver Information Center (DIC) on page 5-22. The increment value used depends on the units displayed. If 1 is on when not in use, SET/- or RES/+ could get bumped and go into cruise when not desired. Keep 1 off when cruise control is not being used.