2015 Buick Encore Owner Manual - Page 253

10-48 Vehicle Care activate the TPMS sensor. A horn chirp confirms that the sensor identification code has been matched to this tire and wheel position. 9. Proceed to the passenger side front tire, and repeat the procedure in Step 8. 10. Proceed to the passenger side rear tire, and repeat the procedure in Step 8. 11. Proceed to the driver side rear tire, and repeat the procedure in Step 8. The horn sounds two times to indicate the sensor identification code has been matched to the driver side rear tire, and the TPMS sensor matching process is no longer active. The TIRE LEARN or TIRE LEARNING ACTIVE message on the DIC display screen goes off. 12. Turn the ignition to LOCK/OFF. . 3. Use the MENU button to select the Vehicle Information Menu (Menu 2) in the Driver Information Center (DIC). 4. Use the thumbwheel (or up and down arrows) to scroll to the Tire Pressure Menu Item screen. 5. Press and hold the SET/CLR button to begin the sensor matching process. A message requesting acceptance of the process may display. 6. If requested, press the SET/CLR button again to confirm the selection. The horn sounds twice to signal the receiver is in relearn mode and the TIRE LEARN or TIRE LEARNING ACTIVE message displays on the DIC screen. 7. Start with the driver side front tire. 8. Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to 13. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading Information label. Tire Inspection We recommend that the tires, including the spare tire, if the vehicle has one, be inspected for signs of wear or damage at least once a month. Replace the tire if: . The indicators at three or more places around the tire can be seen. There is cord or fabric showing through the tire's rubber. The tread or sidewall is cracked, cut, or snagged deep enough to show cord or fabric. The tire has a bump, bulge, or split. . .