2010 Cadillac CTS Owner's Manual - Page 122

4-12 Instruments and Controls 4. The DIC will display Calibrating Drive In Circles. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display Calibration Complete for a few seconds when the calibration is complete. The DIC display will then return to Press To Calibrate Compass. Holding either button down will cause the clock to advance faster. Release the button before the desired time is reached. 3. Push and release either button to adjust the time by one minute increments until the desired time is reached. To calibrate the compass, use the following procedure: Compass Calibration Procedure 1. Before calibrating the compass, check that the compass is set to the correct variance zone. See "Compass Variance (Zone) Procedure" earlier in this section. Do not operate any switches such as window, sunroof, climate controls, seats, etc. during the calibration procedure. 2. Press the vehicle information button until Press To Calibrate Compass displays. 3. Press the set/reset button to start the compass calibration. Power Outlets Accessory power outlets can be used to connect auxiliary electrical equipment, such as a cellular telephone. There are three accessory power outlets. There is an outlet located in the front storage area below the climate control system, one inside the center console storage bin, and one on the rear of the center console. For CTS Wagon model only, there is an additional accessory power outlet located near the rear cargo net. Clock The analog clock is located on the instrument panel above the radio. The clock is not connected with any other vehicle system and runs by itself. To adjust the clock: 1. Locate the adjustment buttons directly below the clock face. 2. Push and hold the right adjustment button to move the clock hands forward or the left adjustment button to make the clock hands go backward.