2014 Cadillac CTS Owner Manual - Page 36

2-6 Keys, Doors, and Windows The vehicle comes with two transmitters. Each transmitter will have a number on top of it, "1" or "2." These numbers correspond to the driver of the vehicle. For example, the memory seat position for driver 1 will be recalled when using the transmitter labeled "1," if enabled through the DIC. See Memory Seats on page 3-7 and Vehicle Personalization on page 5-46. Programming with a Recognized Transmitter A new transmitter can be programmed to the vehicle when there is one recognized transmitter. For vehicles sold in Canada, two recognized transmitters are required to program a new transmitter. 1. Make sure the vehicle is off. 2. Place the recognized transmitter(s) in the cupholder. Have the new transmitter available with you. 3. Insert the vehicle key into the key lock cylinder on the outside of the driver door. 4. Turn the key to the unlock position five times within five seconds. 5. The Driver Information Center (DIC) displays READY TO LEARN ELECTRONIC KEY #2, 3 or 4. / (Remote Start): Press to operate the remote start feature. See Remote Vehicle Start on page 2-11. V / 8 (Remote Trunk/Liftgate Release): Press and hold for about one second to unlock the trunk/ liftgate. The automatic transmission must be in P (Park) or the manual transmission must be in Neutral with the parking brake set. L (Vehicle Locator/Panic Alarm): Press and release to locate the vehicle. The horn sounds three times and the turn signal lamps flash three times. Press and hold L for three seconds to sound the panic alarm. The horn sounds and the turn signal lamps flash for 30 seconds. Press and release L again to stop the alarm. Programming Transmitters to the Vehicle Only RKE transmitters programmed to the vehicle will work. If a transmitter is lost or stolen, a replacement can be purchased and programmed through your dealer. The vehicle can be reprogrammed so that lost or stolen transmitters no longer work. Each vehicle can have up to four transmitters matched to it.