2003 Chevrolet Monte Carlo Owner's Manual - Page 115
2003 Chevrolet Monte Carlo Manual
Page 115 highlights
4. With your preference displayed, press the TUNE DlSP button to select. A chime will be heard to verify the new setting. The new selection will be displayed with an asterisk (*) for one second. FOB PROG (Remote Keyless Entry Transmitter Programming) This feature allows you to match the remote keyless entry transmitter to your vehicle. To match the transmitter do the following: 1. Scroll, using the SEEK PSCAN up or down arrows, until FOB PROG appears on the display. 2. Press the 1 PREV or 2 NEXT button to enter the submenu. BEGIN will be displayed. 3. Press the TUNE DlSP button to start programming. When the message PUSH FOB flashes, press and hold the LOCK and UNLOCK buttons on the first transmitter at the same time for seconds. A chime 15 will be heard to verifythe transmitter is learned. 4. Repeat Step 3 for each additional transmitter. The transmitter is programmed now. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. ORIG. SET (Return to the Original Settings) This feature allows you to return all customization feature settings back to their original factory settings. To reset do the following: 1. Scroll, using the SEEK PSCAN up or down arrows, until ORIG. SET appears on the display. 2. Press the 1 PREV or 2 NEXT button to enter the submenu. SET ALL will appear. 3. With your preference displayed, press the TUNE DlSP button to select. A chime will be heard to verify the new setting. The new selection will be displayed with an asterisk (*) for one second. EXIT (Exit Feature Customization Mode) This feature allows you to exit the vehicle customization programming. To exit do the following: Scroll until EXIT appears on the display. Press the TUNE DlSP button to exit programming. A chime will be heard to verify the exit. The original factory settings are now reset. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. 2-50