2004 Chevrolet Monte Carlo Owner's Manual - Page 109
2004 Chevrolet Monte Carlo Manual
Page 109 highlights
Your vehicle was originally programmed to Mode 4. The mode may have been changed since then. To determine the current mode, or to change the mode, do the following: 1. Scroll, using the SEEK PSCAN up or down arrows, until AUTOLOCK appears on the display. 2. Press the 1 PREV or 2 NEXT button to enter the submenu. The current selection will have an asterisk (*) next to it. If you do not wish to change the current mode, you can either exit the programming mode by following the directions later in this section or program the next feature available on your vehicle. 3. Scroll, using the 1 PREV or 2 NEXT buttons, through the modes to change the current mode. 4. With your preference displayed, press the TUNE DISP button to select. A chime will be heard to verify the new setting. The new selection will be displayed with an asterisk (*) for one second. The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. FOB LIGHT (Remote Visual Verification) This feature allows the exterior lights to flash when the remote keyless entry transmitter is used to lock or unlock the vehicle, or to program no verification. Programmable Modes Mode 1: OFF Mode 2: On - One flash for each remote lock/two flashes for each remote unlock. Your vehicle was originally programmed to Mode 2. The mode may have been changed since then. To determine the current mode, or to change the mode, do the following: 1. Scroll, using the SEEK PSCAN up or down arrows, until FOB LIGHT appears on the display. 2. Press the 1 PREV or 2 NEXT button to enter the submenu. The current selection will have an asterisk (*) next to it. If you do not wish to change the current mode, you can either exit the programming mode by following the directions later in this section or program the next feature available on your vehicle. 2-45