2005 Chevrolet Uplander Owner's Manual - Page 70

7. Push and pull the child restraint in different directions to be sure it is secure. 8. If the airbag or airbags are off, the off indicator on the instrument panel will be lit and stay lit when the key is turned to RUN or START. If a child restraint has been installed and the on indicator is lit, turn the vehicle off. Remove the child restraint from the vehicle and reinstall the child restraint. If after reinstalling the child restraint and restarting the vehicle, the on indicator is still lit, check to make sure that the vehicle's seatback is not pressing the child restraint into the seat cushion. If this happens, slightly recline the vehicle's seatback and adjust the seat cushion if possible. Also make sure the child restraint is not trapped under the vehicle head restraint. If this happens, adjust the head restraint. If the on indicator is still lit, secure the child in the child restraint in a rear seat position in the vehicle if one is available and check with your dealer. To remove the child restraint, if the top tether is attached to the top tether anchor, disconnect it. Unbuckle the vehicle's safety belt and let it go back all the way. The safety belt will move freely again and be ready to work for an adult or larger child passenger. Built-In Child Restraint WARNING! DEATH or SERIOUS INJURY can occur: • Follow all instruction on the child restraint and in the vehicle's owner's manual. If your vehicle has this feature, the built-in child restraint is located in the passenger-side position in the second row. This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards. 1-64