2006 Chevrolet Avalanche Owner's Manual - Page 136

Reprogramming a Single Universal Home Remote Button To program a device to Universal Home Remote using a Universal Home Remote button previously trained, follow these steps: 1. Press and hold the desired Universal Home Remote button. Do not release the button. 2. The indicator light will begin to flash after 20 seconds. While still holding the Universal Home Remote button, proceed with Step 2 under "Programming Universal Home Remote" shown earlier in this section. For additional information on Universal Home Remote, see Customer Assistance Offices on page 7-4. Cupholder(s) Your vehicle may be equipped with cupholders for the front and rear passengers. The cupholders are located in the center console for the front passengers and on the rear of the center console for the rear passengers. To use the front cupholders, press down on the access door and release. The door will then open. Push the door back down to close it. To use the rear cupholders, pull down on the door located on the back of the console. The front cupholder may be removed for cleaning by pushing down and then back on the cupholder. Storage Areas Glove Box Open the glove box by pulling the bottom of the handle upward. Center Overhead Console Your vehicle may have an overhead console equipped with reading lights and a small storage area. Press the button next to the light to turn it on. Press it again to turn it off. 2-62