2006 Chevrolet Uplander Owner's Manual - Page 162

Setting Cruise Control 4. Remove your foot from the accelerator pedal. This symbol will appear on the instrument panel cluster when the cruise control is set. {CAUTION: If you leave your cruise control on when you are not using cruise, you might hit a button and go into cruise when you do not want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control. This symbol will disappear when the brakes are applied or the cruise control is cancelled. It will reappear when the set cruise speed is resumed. 1. Push the button at the end of the cruise control lever to turn the cruise control on. 2. Accelerate to the desired speed. 3. Push down on the cruise control lever and release it. This will set the speed in cruise control. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control shuts off. But the cruise control does not need to be reset. Once the vehicle is traveling approximately 25 mph (40 km/h) or more, the cruise control lever can be pushed upward toward the plus (resume/accelerate) position to return to the preset cruise speed. The vehicle will return to and stay at the preset cruise speed. If the cruise control lever is pushed up and held toward the plus (resume/accelerate) position, the vehicle speed will increase until the lever is released or the brakes are applied. Do not continue to hold the lever in the plus (resume/accelerate) position, unless a faster speed is desired. 3-12