2008 Chevrolet HHR Owner's Manual - Page 334
2008 Chevrolet HHR Manual
Page 334 highlights
7. Push the On/Off switch to the I (on) position. The sealant and compressor kit injects sealant and air into the tire. Sealant can leak from the puncture until the vehicle is driven and the hole has sealed. The pressure gage will initially show a high pressure while the compressor pushes the sealant into the tire. Once the sealant is completely dispersed into the tire, the pressure will quickly drop and start to rise again as the tire inflates with air. 8. Inflate the tire to the recommended inflation pressure, found on the Tire and Loading Information label located on the vehicle's center pillar (B-pillar) below the vehicle's door latch, using the air pressure gage on the top of the unit. The pressure gage reads high while the compressor is running. Turn the compressor off to get an accurate pressure reading. Notice: If the recommended pressure cannot be reached after 15 minutes, the vehicle should not be driven farther. Damage to the tire is severe and the sealant will not be effective. Remove the air compressor plug from the accessory power outlet and unscrew the inflating hose from the tire valve. See Roadside Assistance Program on page 7-6 for more information. 9. Push the sealant and compressor kit switch to the O (off) position. 10. The tire is not sealed and will continue to leak air until the vehicle is driven and the sealant is distributed in the tire. Steps 11 through 18 must be done right after Step 9. 11. Unplug the air compressor accessory plug from the accessory power outlet in the vehicle. 12. Disconnect the sealant filling hose from the tire valve stem, by turning it counterclockwise, and replace the tire valve stem cap. Be careful when handling the tire inflator components as they could be hot after usage. 13. Wrap the sealant filling hose around the air compressor channel to stow it in its original location. 14. Stow the air compressor accessory plug back in the air compressor. To do this, wrap the air compressor accessory plug, snap in the plug, and then push in the bottom and then the top of the wrapped air compressor accessory plug. 5-80
![](/manual_guide/autos/2008-chevrolet-hhr-owners-manual-a88a235/334.png)