2011 Chevrolet Cruze Owner's Manual - Page 230

9-34 Driving and Operating Uplevel and United States) on page 5‑27. When this message is displayed and/or d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. If d comes on and stays on, reset the system by: 1. Stopping the vehicle. TCS/StabiliTrak Light 2. Turning the engine off and waiting 15 seconds. 3. Starting the engine. If d still comes on and stays on at a speed above 20 km/h (13 mi/h), see your dealer for service. StabiliTrak is on automatically whenever the vehicle is started. To assist with directional control of the vehicle, the system should always be left on. StabiliTrak Off Light TCS Off Light When the stability control system activates, d flashes on the instrument panel. This also occurs when traction control is activated. A noise may be heard or vibration may be felt in the brake pedal. This is normal. Continue to steer the vehicle in the intended direction. If there is a problem detected with StabiliTrak, SERVICE STABILITRAK is displayed on the Driver Information Center (DIC). See Vehicle Messages (Canada Base Level) on page 5‑26 or Vehicle Messages (Canada StabiliTrak can be turned off if needed by pressing and holding g until g and i come on the instrument panel. When StabiliTrak is turned off, the system will not assist with directional control of the vehicle or limit wheel spin. Driving should be adjusted accordingly. Press and release g again to turn the system back on. If cruise control is being used when StabiliTrak activates, cruise control will automatically disengage. Press the cruise control button to reengage when road conditions allow. See Cruise Control on page 9‑35 for more information. TCS/StabiliTrak Button g is located on the console.