2006 Chrysler 300 Owner Manual SRT8 - Page 117
2006 Chrysler 300 Manual
Page 117 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 117 4. The EVIC display will show "Channel X Training" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC display shows "Channel X Trained". NOTE: If the EVIC display shows "Did Not Train" repeat steps 2-4. 5. Press and hold the just trained HomeLink button and observe the EVIC display. If the EVIC display shows "Channel X Transmit" (where X is Channel 1, 2, or 3), programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with ЉProgrammingЉ step two. Do not repeat step one. NOTE: If your hand-held transmitter appears to program the universal transceiver, but your garage door does not operate using the transmitter and your garage door opener was manufactured after 1995, your garage door opener may have a multiple security code system (rolling code system). Please proceed to steps 6-8 to complete the programming of a rolling code equipped device (most common garage door openers require this step. 6. At the garage door opener receiver (motor-head unit) in the garage, locate the ЉlearnЉ or ЉsmartЉ button. This can usually be found where the hanging antenna wire is attached to the motor-head unit. 7. Firmly press and release the ЉlearnЉ or ЉsmartЉ button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate step eight. 8. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the ؆press/hold/release؆ sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink should now activate your rolling code equipped device. 3