2009 Chrysler Town & Country Owner Manual - Page 31

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 • The engine can be started two consecutive 15-minute equipped). Then, prior to the end of the 15-minute cycle, cycles with the RKE transmitter. However, the ignition insert the key into the ignition switch and turn the switch switch must be turned to the ON position before you to the ON position. can repeat the start sequence. NOTE: To Enter the Vehicle After Remote Start • The ignition switch must be in the ON position in To enter the vehicle while the engine is running during a order to drive the vehicle. Remote Start, you must first unlock the vehicle using the • For vehicles equipped with the Electronic Vehicle UNLOCK button on the transmitter. After the vehicle is Information Center (EVIC), the message "Insert Key/ unlocked, you can enter the vehicle, insert the key into Turn to ON" will flash in the EVIC until you insert the the ignition switch and move it to the ON position, key. Once inserted, the message "Turn to ON" will otherwise the engine will shut off at the end of 15- minute flash in the EVIC until you turn the key to ON. cycle. Cancel Remote Start To Exit Remote Start Mode and Drive the Vehicle Remote Starting will also cancel if any of the following Before the end of the 15-minute cycle, press and release occur: the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if • The engine stalls or engine speed exceeds 2500 rpm • Any engine warning lights come on 2