2008 Dodge Challenger Owner Manual SRT8 - Page 287
2008 Dodge Challenger Manual
Page 287 highlights
WHAT TO DO IN EMERGENCIES 285 20. Release the parking brake and drive the vehicle for approximately 10 minutes to ensure optimum distribution of the tire sealant within the tire. 21. Turn on the hazard warning flashers. 22. Move the shift lever to the PARK position, turn OFF the engine, and set the parking brake. 23. Disconnect the air pump hose 1 from the underside of the sealant bottle 5 by flipping the hose valve open. 24. Connect the air pump hose valve to the tire valve and flip the hose valve closed. 25. Check the pressure in the tire by reading the pressure gauge 4. If the pressure is 19 psi (1.3 bar) or greater, proceed to the following step. NOTE: If the pressure is less than 19 psi (1.3 bar), the tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. 26. Leave the parking brake set and the shift lever in PARK and start the engine. 27. Inflate the tire to the pressure indicated on the tire pressure label on the driver-side latch pillar by pressing the switch 3 on the air pump to I (ON) and watching the pressure gauge. When the tire pressure is set to the pressure indicated on the tire pressure label, press the AIR PUMP switch 3 to 0 (OFF) and turn off the engine. 28. Disconnect the TIREFIT system from the tire and reinstall the valve cap. 29. Place the sealant kit back in the trunk of the vehicle. Replace the sealant bottle at your nearest authorized MOPAR parts dealership. 30. Have the tire inspected at the earliest opportunity at an authorized dealer or tire service center. 6