2008 Dodge Dakota Owner Manual - Page 137
2008 Dodge Dakota Manual
Page 137 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 137 Then proceed with Step 4 under "Programming HomeLink." earlier in this section. Using HomeLinkா To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc. The hand-held transmitter of the device may also be used at any time. Reprogramming a Single HomeLinkா Button To re-program a channel that has been previously trained, follow these steps: 1. Turn the ignition switch to the ON/RUN position. 2. Press and hold the desired HomeLinkbutton for 20 seconds until the indicator(s) starts to flash. Do not release the button. 3. Without releasing the button, proceed with PROGRAMMING HOMELINK Step #2 and follow all remaining steps. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the indicators begin to flash. Note that all channels will be erased. Individual channels cannot be erased. The HomeLink Universal Transceiver is disabled when the Vehicle Theft Alarm is active. Troubleshooting Tips If you are having trouble programming HomeLink, here are some of the most common solutions: • Replace the battery in the original transmitter. 3