2008 Dodge Nitro Owner Manual - Page 172
2008 Dodge Nitro Manual
Page 172 highlights
172 INSTRUMENT PANEL AND CONTROLS bulb check. If the bulb does not come on during starting, see your authorized dealer for service. If the light stays on, it may be an indication that the parking brake has not been released, or there is a low brake fluid level. If the light remains on when the parking brake has been disengaged, and the fluid level is at the full mark on the master cylinder reservoir, it indicates a possible brake hydraulic system malfunction or a problem with the Brake Booster. In this case, the light will remain on until the condition has been corrected. If the problem is related to the brake Booster the ABS pump will run when applying the brake. The "BRAKE" warning light will flash whether or not it is in gear, if the park brake is applied, and the engine is running (manual transmission only). The "BRAKE" warning light will remain on steady with the park brake on and the shifter in the P (Park) position. If shifted out of P (Park), it will begin to flash (automatic transmission only). If brake failure is indicated, immediate repair is necessary. Operating the vehicle in this condition is dangerous! 15. Electronic Throttle Control (ETC) Warning Light - If Equipped This light informs you of a problem with the Electronic Throttle Control system. If a problem is detected the light will come on while the engine is running. If the light remains lit with the engine running your vehicle will usually be drivable, however, see your dealer for service as soon as possible. If the light is flashing when the engine is running, immediate service is required and you may experience reduced performance, an elevated/rough idle or engine stall and your vehicle may require towing. The light will come on when the ignition is first turned on and remain on for 15 seconds as a bulb check. If the light does not come on during starting, have the system checked by an authorized dealer.