2009 Dodge Dakota Crew Cab Owner Manual - Page 147
2009 Dodge Dakota Crew Cab Manual
Page 147 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145 3. Simultaneously, press and hold both the chosen HomeLinkbutton and the hand-held transmitter button until the indicator(s) change from a slow to a rapid flash rate. Then release both the HomeLink and hand-held transmitter buttons. It may take up to 30 seconds, or longer in rare cases. The garage door may open & close while you train. If the signal is too weak to train, replace the battery in the original hand-held transmitter. NOTE: Some gate operators and garage door openers may require you to replace Step #3 with procedures noted in the "Gate Operator/Canadian Programming" section. 4. Press and hold the just-trained HomeLink button. If the indicator(s) blink rapidly for two seconds and then remains constant, continue with the next section: Programming A Rolling Code System. NOTE: After training a HomeLink channel, if the garage door does not operate with HomeLink and the garage door opener was manufactured after 1995, the garage door opener may have rolling code. If so, proceed to the heading, "Programming A Rolling Code System." 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "learn" or "training" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open & close the door). 3