2009 Dodge Dakota Crew Cab Owner Manual - Page 150
2009 Dodge Dakota Crew Cab Manual
Page 150 highlights
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 1. Turn the ignition switch to the ON/RUN position. 2. Press and hold the desired HomeLink button, for 20 seconds, until the indicator(s) starts to flash. Do not release the button. 3. Without releasing the button, proceed with PROGRAMMING HOMELINK, Step #2, and follow all remaining steps. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons, for 20 seconds, until the indicators begin to flash. Note that all channels will be erased. Individual channels cannot be erased. The HomeLink Universal Transceiver is disabled when the Vehicle Theft Alarm is active. Troubleshooting Tips If you are having trouble programming HomeLink, here are some of the most common solutions: • Replace the battery in the original transmitter. • Press the "Learn" button on the Garage Door Opener to complete the training for Rolling Code. • Did you unplug the device for training, and remember to plug it back in? If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at www.HomeLink.com, for information or assistance. General Information This device complies with FCC rules part 15 and Industry Canada RSS-210. Operation is subject to the following two conditions: 1. This device may not cause harmful interference