2014 Dodge Durango Owner Manual - Page 426

424 STARTING AND OPERATING Transfer Case Position Indicator Messages The Transfer Case Position Indicator messages (AWD AUTO and LOW RANGE) are located in the EVIC (Electronic Vehicle Information Center) and indicate the current and desired transfer case selection. Refer to "Electronic Vehicle Information Center (EVIC)" in "Understanding Your Instrument Panel" for further information. When you select a different transfer case position, the position indicator lights will do the following: If One Or More Shift Conditions Are Not Met: 1. The indicator light for the current position will remain ON. 2. The newly selected position indicator light will continue to flash. 3. The transfer case will not shift. NOTE: Before retrying a selection, make certain that all the necessary requirements for selecting a new transfer If All Shift Conditions Are Met: case position have been met. To retry the selection, turn the control knob back to the current position, wait five 1. The current position indicator light will turn OFF. seconds, and retry selection. To find the shift require2. The selected position indicator light will flash until the ments, refer to the ЉShifting ProcedureЉ for your transfer transfer case completes the shift. case, located in this section of the owner's manual. 3. When the shift is complete, the indicator light for the The "SERV AWD" Warning Light monitors the electronic selected position will stop flashing and remain ON. shift all-wheel drive system. If this light remains on after engine start up or illuminates during driving, it means