1997 Ford Aerostar Owner's Manual - Page 226

Removing jumper cables 1. Always remove the jumper cables in the reverse order. Remove the negative ( ) end of the jumper cable from the metallic surface on the engine or frame of the disabled vehicle. Remove the negative ( ) cable from the booster battery. Remove the positive (+) cable from the booster battery. Remove the other end of the positive (+) cable from the discharged battery. 2. 3. 4. After the vehicle is started, let it idle for a while to let the engine "relearn" its idle conditions. Drive it around for a while with all electrical accessories turned off to let the battery recharge. Driveability may be deteriorated slightly until all drive modes are "relearned." You may need to use a battery charger to fully recharge the battery. If you need to replace your battery, see Battery in the Maintenance and Care chapter. Towing Your Vehicle The recommended method to tow your Aerostar is with flatbed or wheel lift equipment. However, slingbelt towing is acceptable. On vehicles equipped with an under-vehicle spare tire carrier, remove the tire assembly from the carrier and store it in a secure area before towing. For E-4WD vehicles, the 4-wheel drive system must be disabled prior to towing. The transmission must be in N (Neutral) and the ignition switch must be in the OFF position to disable the Electronic 4-Wheel Drive System. 226