2007 Ford Freestar Owner Guide 2nd Printing - Page 78

Driver Controls Erasing HomeLinkா buttons To erase the three programmed buttons (individual buttons cannot be erased): • Press and hold the two outer HomeLink௡ buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink௡ is now in the train (or learning) mode and can be programmed at any time beginning with Step 2 in the "Programming" section. Reprogramming a single HomeLinkா button To program a device to HomeLink௡ using a HomeLink௡ button previously trained, follow these steps: 1. Press and hold the desired HomeLink௡ button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink௡ button, follow Step 2 in the "Programming" section. For questions or comments, contact HomeLink௡ at www.homelink.com or 1-800-355-3515. MESSAGE CENTER (IF EQUIPPED) With the ignition in the ON position, the message center, located on your instrument cluster, displays important vehicle information through a constant monitor of vehicle systems. You may select display features on the message center for a display of status preceded by a brief indicator chime. The system will also notify you of potential vehicle problems with a display of system warnings followed by an indicator chime. Selectable features Reset Press this control to select and reset functions shown in the INFO menu and SETUP menu. 78 2007 Freestar (win) Owners Guide (post-2002-fmt) USA (fus)