2008 Ford Crown Victoria Owner's Manual - Page 87

Locks and Security 4. Press the power door unlock control three times. 5. Turn the ignition back to the 3 (ON) position. 6. The door locks will lock/unlock to confirm programming mode is entered/active. 7. With the ignition still in the 3 (ON) position, for the autolock feature, press the unlock control once then press the lock control once. The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated. For the auto-unlock feature, press the lock control once, then press the unlock control once. The horn will chirp once if auto-unlock was deactivated or twice (one short and one long chirp) if auto-unlock was activated. If any door, the hood, or the deck lid is open, the horn will chirp twice, and the procedure will need to be performed again. 8. After having waited the necessary time for the programming to confirm, turn the ignition to the 1 (OFF/LOCK) position. Once disabled, the autolock or auto-unlock feature can be enabled by repeating the procedure in Steps 1-8. CHILDPROOF DOOR LOCKS When these locks are set, the rear doors cannot be opened from the inside. The rear doors can be opened from the outside when the doors are unlocked. The childproof locks are located on rear edge of each rear door and must be set separately for each door. Setting the lock for one door will not automatically set the lock for both doors. Move lock control up to engage the childproof lock. Move control down to disengage childproof locks. 87 2008 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus)