2008 Ford Escape Owner Guide 3rd Printing - Page 87

Locks and Security Switching from two step to one step door unlocking Unlocking can be switched between two step and one step door and buttons unlocking by pressing and holding both simultaneously on the remote entry transmitter for approximately 4 seconds. The turn signal will flash twice to indicate that the vehicle has switched to one step unlocking. Repeat the procedure to switch back to two step unlocking. Locking the doors 1. Press and release to lock all the doors. Assuming all vehicle doors and the liftgate are properly closed, the park/turn lamps will flash once. and release again within three seconds to confirm that all the 2. Press doors and liftgate are closed and locked. Note: The doors will lock again and the horn will chirp once. If any of the doors or the liftgate are not properly closed, the horn will control is chirp twice and park/turn lamps will not flash when the pressed. Opening the liftgate (if equipped) Press twice within 3 seconds to open the liftgate glass. Car finder twice within three seconds. The horn will chirp and the turn Press lamps will flash. It is recommended that this method be used to locate your vehicle, rather than using the panic alarm. Sounding a panic alarm to activate the alarm. To deactivate the feature, press the Press control again, turn the ignition to the 3 (RUN) or 4 (START) position, or wait for the alarm to time out in approximately 3 minutes. Note: The panic alarm will only operate when the ignition is in the 1 (LOCK) position. Replacing the battery The Integrated Keyhead Transmitter uses one coin type three-volt lithium battery CR2032 or equivalent. 87 2008 Escape (204) Owners Guide (post-2002-fmt) USA (fus)