2008 Ford Explorer Owner Guide 2nd Printing (Spanish) - Page 717

Driving Traction Control, and Brake Traction Control) will be activated at start will flash up. When the system is left active, the "sliding car" icon only when any of the components of the system are affecting the vehicle's performance, otherwise the light will remain off. Consequently, will not be illuminated during most of your the "sliding car" icon normal driving. The AdvanceTrac௡ with RSC button, located on the center stack of the instrument panel, allows the driver to control certain features of the AdvanceTrac௡ with RSC system below 25 mph (40 km/h). If the vehicle is below 25 mph (40 km/h), momentarily pressing the AdvanceTrac௡ with RSC button will disable RSC, ESC and Engine . Traction Control and steadily illuminate the "sliding car" icon Pressing and holding the AdvanceTrac௡ with RSC button for more than five seconds will further disable the brake portion of the Traction Control will flash momentarily and then feature and the "sliding car" icon illuminate steady. If the vehicle is above 25 mph (40 km/h), momentarily pressing the AdvanceTrac௡ with RSC button will steadily illuminate the "sliding car" , however, the AdvanceTrac௡ with RSC system will remain icon enabled until the vehicle speed drops below 25 mph (40 km/h). If the vehicle speed decreases below 25 mph (40 km/h), the system will become deactivated, but if the vehicle speed subsequently increases to above 25 mph (40 km/h), the system will again become active. In general, the system will be active at all times the vehicle speed is above 25 mph (40 km/h). In R (Reverse), ABS and the Traction Control feature will continue to function, however ESC and RSC are disabled. All these conditions are normal during AdvanceTrac௡ with RSC operation. Refer to the following table. 273 2008 Explorer (exp) Owners Guide (post-2002-fmt) USA (fus)