2008 Ford F250 Diesel Supplement 4th Printing - Page 87
2008 Ford F250 Manual
Page 87 highlights
Scheduled Maintenance: F-Super Duty 140,000 miles (224,000 km) ❑ Change engine oil and replace oil filter ❑ Rotate tires, inspect tires for wear and measure tread depth and inspect wheels for endplay and noise (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect air filter restriction gauge, replace filter as required Replace engine- and frame-mounted fuel filters Inspect steering linkage, suspension, driveshaft, ball joints and U-joints Inspect engine and fuel cooling systems and hoses Inspect brake pads/shoes/rotors/drums, brakes lines & hoses, and parking brake system Inspect exhaust system and heat shields Inspect and lubricate ball joints and tie rod ends (if equipped with zerk fittings) Inspect and lubricate front axle U-joints (4x4 vehicles) Perform multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 150,000 miles (240,000 km) Change engine oil and replace oil filter Rotate tires, inspect tires for wear and measure tread depth and inspect wheels for endplay and noise (vehicles with dual rear wheels should only rotate if unusual wear is noted) Inspect air filter restriction gauge, replace filter as required Replace accessory drive belt if not replaced in the last 100,000 miles (160,000 km) Replace wheel bearing and wheel bearing grease seals on 4x2 vehicles (if non-sealed bearings) Inspect exhaust system and heat shields Vehicles equipped with the Torqshift transmission and the externally mounted remote filter element, replace the automatic transmission fluid and the externally mounted filter element (if equipped). Inspect automatic transmission fluid level on all other vehicles if equipped with dipstick. Consult your dealer for particular requirements. Change transfer case fluid (4x4 vehicles) (refer to Special Operating Conditions for more information) Change front axle lubricant Change rear axle fluid (DANA axles only. Refer to Special Operating Conditions for more information) Inspect and lubricate front steering linkage, ball joints, suspension, tie rod ends, driveshaft and U-joints Inspect automatic transmission fluid level on all vehicles equipped with the Torqshift transmission Perform multi-point inspection (recommended) DEALER VALIDATION: RO#: DATE: P&A CODE: MILEAGE: 87