2008 Ford F250 Owner Guide 4th Printing - Page 155

Locks and Security To reprogram the remote entry transmitters: 1. Ensure the vehicle is electronically unlocked. 2. Put the key in the ignition. 3. Cycle eight times rapidly (within 10 seconds) between the 1 (OFF/LOCK) position and 3 (ON). Note: The eighth turn must end in the 3 (ON) position. The doors will lock, then unlock, to confirm that the programming mode has been activated. 4. Within 20 seconds press any button on the remote entry transmitter. Note: If more than 20 seconds have passed you will need to start the procedure over again. The doors will lock, then unlock, to confirm that this remote entry transmitter has been programmed. 5. Repeat Step 4 to program each additional remote entry transmitter. 6. Turn the ignition to the 1 (OFF/LOCK) position after you have finished programming all of the remote entry transmitters. Note: After 20 seconds, you will automatically exit the programming mode. The doors will lock, then unlock, to confirm that the programming mode has been exited. Perimeter lamps illuminated entry With the Remote Keyless Entry system, the following items will control on the transmitter is pressed: illuminate when the • Headlamps • Parklamps • Tail lamps The lamps will automatically turn off: • if the ignition switch is turned to the 3 (ON) position, or • the Remote Keyless Entry Transmitter lock control is pressed, or • the vehicle is locked using the keyless entry keypad (if equipped), or • after 25 seconds of illumination. Note: On some vehicles, the perimeter lamps illuminated entry feature will not activate in daylight conditions. 155 2008 F-250/350/450/550 (f23) Owners Guide (post-2002-fmt) USA (fus)