2008 Ford F250 Special Off-Road Package Supplement 1st Printing - Page 16

Driver Controls Triple line Use the same techniques as a double line. Select a strong mounting location on your vehicle for the snatch block and the clevis/D-shackle. Keep at a 90° angle between the winch and run the wire rope to the first anchor point and through the snatch block. Secure the rope back to the vehicle. Put the rope through the snatch block and secure it with the clevis/D-shackle on the vehicle as close to the winch as possible. Run the rope to the final anchor point. Secure to the anchor point with a tree protector or choker chain. Attach the clevis/D-shackle. Attach the clevis/D-shackle to the two ends of the protector/ chain, being careful not to overtighten (tighten and back off 1⁄2 turn). Secure the winch hook. While keeping the line near the ground, insert the winch hook through the clevis/D-shackle. Check the anchor. Make sure all connections are secured and free of debris before continuing with the winching procedure. Maintenance • Inspect the wire rope before and after each winching operation. If the wire rope has become kinked or frayed, it needs to be replaced. Be sure to also inspect the winch hook and hook pin for signs of wear or damage. Replace as necessary. • Keep winch, wire rope and switch control free from contaminants. Use a clean rag or towel to remove any dirt and debris. If necessary, unwind the winch completely (leaving a minimum of five wraps of rope on the drum) and wipe it clean before rewinding it. Using a light oil on the rope and winch hook can keep rust and corrosion from forming. • Operating the winch for an extended period of time places an additional load on your vehicle battery. Be sure to check and maintain your battery and battery cables according to manufacturer guidelines. Also, inspect the switch control and all electrical connections to be certain they are clean and tight fitting. • Inspect the remote control, if so equipped, for damage. Be sure to cap the remote socket to prevent dirt and debris from entering the connections. Store the remote control in a dry, protected area. • No lubrication is required for the life of the winch. 16 2008 F-250/350/450/550 (f23) Supplement USA (fus)