2010 Ford Fusion Owner Guide 4th Printing - Page 65

Lights 3. Reaching through the wheel well, remove the rubber bulb access cover from the housing. 4. Remove the bulb socket by rotating it counterclockwise, then pull it straight out of the lamp assembly. 5. Disconnect the electrical connector from the bulb socket and discard the old bulb socket. WARNING: Handle a halogen headlamp bulb carefully and keep out of children's reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated. 6. Connect the new bulb socket to the electrical connector. 7. Install the new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to the locked position. 8. Install the rubber bulb access cover to the housing. 9. Re-apply pressure around the housing to make sure the protective rubber cover is completely seated. 10. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. 65 2010 Fusion (fsn) Owners Guide, 4th Printing USA (fus)