2013 Ford Mustang Owner Manual Printing 3 - Page 145

144 Universal Garage Door Opener (If Equipped) Programming Note: Put a new battery in the hand-held transmitter. This will ensure quicker training and accurate transmission of the radio-frequency signal. 1. With your vehicle parked outside of the garage and your key in the ignition, turn the key so that it is in the on position. 2. Hold your hand-held, garage door transmitter 1-3 inches (2-8 centimeters) away from the HomeLink button you want to program. 3. Press and hold both the HomeLink button you want to program and the hand-held transmitter button until the HomeLink indicator light changes from flashing slowly to rapidly, then release. 4. Press and hold the HomeLink button you programmed for 5 seconds, then release. You may need to do this twice to activate the door. If your garage door does not operate, watch the HomeLink indicator light. If the indicator light stays on, the programming is complete. Press and release the programmed HomeLink button, and then begin programming your garage door opener. See below for Steps 5 - 7. If the indicator light flashes rapidly for two seconds and then turns to a constant light, the HomeLink button is not programmed yet. Do the following: Press and hold the HomeLink button while you press and release the hand-held transmitter button every 2 seconds. The HomeLink indicator light will flash slowly and then rapidly once the HomeLink function button recognizes and accepts the hand-held transmitter's radio frequency signal. After programming the HomeLink button, follow Steps 5 - 7 as listed below to program your garage door opener. Note: You may need a ladder to reach the unit and you may need to remove the cover or lamp lens on your garage door opener. 5. Press the learn button on the garage door opener motor, and then you have 30 seconds to complete the next step. 2013 05+ Mustang (197) Owners Guide gf, 3rd Printing USA (fus)