2014 Ford Explorer Owner Manual Printing 1 - Page 246

Cruise Control Overriding Adaptive Cruise Control 245 WARNING: Whenever the driver is overriding the ACC by pressing the accelerator pedal, the ACC will not automatically apply the brakes to maintain separation from any vehicle ahead. You can override the set speed and gap distance by pressing the accelerator pedal. When you are overriding the system, the green indicator light illuminates and the follow vehicle does not show in the information display. The system will resume operation when you release the accelerator pedal. The vehicle speed will decrease to the set speed, or a lower speed if following a slower vehicle. Changing the Set Speed There are three ways to change the set speed: • Accelerate or brake to the desired speed and press SET upward and release. • Increase or decrease the speed by holding SET upward or downward until the desired set speed is shown on the information display. The vehicle speed will gradually change to the selected speed. • Increase or decrease the speed in increments of 1 mph (2 km/h) by briefly pressing SET upward or downward. The system may apply the brakes to slow your vehicle down to the new set speed. The set speed will display continuously in the information display while the system is active. Resuming the Set Speed Note: Resume should only be used if you are aware of the set speed and intend to return to it. Press and release RES. Your vehicle will return to the previously set speed. The set speed will display continuously in the information display while the system is active. 2014 Explorer (exp) Owners Guide gf, 1st Printing, April 2013 USA (fus)