2015 Ford Transit 150 Wagon Owner Manual Printing 3 - Page 108
2015 Ford Transit 150 Wagon Manual
Page 108 highlights
Starting and Stopping the Engine When you start the engine, the idle speed increases, this helps to warm up the engine. If the engine idle speed does not slow down automatically, have your vehicle checked by an authorized dealer. Note: Do not touch the accelerator pedal. 1. Fully press the brake pedal. 2. Turn the ignition key to position II to switch the ignition on. 3. Turn the ignition key to position III to start your vehicle. Release the key when the engine starts. Note: You can only operate the starter for a limited period of time, for example 10 seconds. The number of start attempts is limited to approximately six. If you exceed this limit, the system will not allow you to try again until a period of time has elapsed, for example 30 minutes. Flooded Engine Move the transmission selector lever to position P. 2. Fully depress the accelerator pedal and hold it there. 3. Start the engine. Note: If the engine does not start, repeat the cold or hot engine procedure. 1. STARTING A DIESEL ENGINE WARNINGS Do not use starting fluid, for example ether, in the air intake system (see air filter decal). Starting fluids could cause immediate explosive damage to the engine. Failure to follow this warning could result in fire, serious personal injury or death. Do not add gasoline, gasohol, alcohol or Kerosene to diesel fuel. This action creates a serious fire hazard and will result in poor engine performance. Engine damage caused by the use of incorrect fuel is not covered by the vehicle warranty. Note: Avoid shutting the engine down after an extensive idling period. Drive your vehicle for several miles with the engine at normal operating temperatures under a moderate load. Engine Idle Speed after Starting The speed at which the engine idles immediately after starting will adjust automatically to minimize vehicle emissions and maximize cabin comfort and fuel economy. The idle speed will vary depending on certain factors. These include vehicle component and ambient temperatures as well as electrical and climate system demands. Cold or Hot Engine If the engine does not start within 10 seconds, wait for a short period and try again. If the engine does not start after three attempts, wait 10 seconds and follow the flooded engine procedure. If you have difficulty starting the engine when the temperature is below -13°F (-25°C), press the accelerator pedal to the mid-way point of its travel and try again. Engine Glow Plugs The powertrain control and glow plug control modules operate the glow plug system. When you switch the ignition on the glow plug control module immediately energizes the glow plugs. The glow plug control module using the engine coolant temperature, barometric pressure sensor 105 Transit (TTH) Canada/United States of America, enUSA, Edition date: 03/2014, Third Printing