1996 GMC Yukon Owner's Manual - Page 24

Replacing the Rear Seat Safetv Belts: They're for Everyone This part of the manual tells you how to use safety belts properly. It also tells you some things you should not do with safety belts. And it explains the Supplemental Inflatable Restraint (SIR), orair bag system. ~ To put the seat back in, hold the seat sideways and put it into the vehicle. Turn the seat to the forward position and set it down, with the latches at the bottom of the seat over the hooks in the floor. Pull up on the center release handle and let the seat drop into place. Release the handle to let the seat latch close and make sure it locks into place. Then, move the seatback release lever at the right rear of the seat toward the center of the vehicle and raise the seatback. After returning the seatback tothe upright position, push the seatback forward to make sure it is locked in place. Then, return the outside passenger position safety belts to the seat frame buckles, so they will be available for rear seat passengers to use. A CAUTION: Don't let anyone ride where he she can't wear or a safety belt properly.If you are ina crash and you're not wearing a safety belt, your injuries can be much worse. You can hit things inside the vehicle or be ejected fromit. You can be seriously injured or killed. In the same crash, you might not be if you are buckledup. Always fasten your safety belt, and check that your passengers' belts are fastened properly too. I 1-16