2009 GMC Yukon Owner's Manual - Page 183

To remove the cover, from a regular wheelbase model: 1. Let the cover go all the way into the holder. 2. Then, grasping the driver's side cover end cap, push the cover end cap toward the passenger side of the vehicle. 3. Swing the cover rearward and take it out of the vehicle. To put the cover in the vehicle: 1. Make sure the cover slot in the holder faces rearward with the round surface facing down. 2. Then, hold the cover at an angle and place the cover end cap into the slot in the passenger side trim panel. 3. Move the other end of the cover forward and hold it next to the driver's side trim panel slot. 4. Press the end caps in, to allow the cover to fit into the trim slot. 5. Pull lightly on the cover holder to make sure it is secure. On extended wheelbase models there are two cover positions. The slots furthest forward allow the cover to be used if the third seat is removed or folded down. The cover can be installed and removed from either side. Sunroof Your vehicle may be equipped with a power sliding sunroof. To open or close the sunroof, the ignition needs to be turned to ON/RUN, or Retained Accessory Power (RAP) must be active. When RAP is active, the sunroof will work for 10 minutes after the ignition is turned off, or until a front door is opened. See Retained Accessory Power (RAP) on page 2-26 for more information. There are two switches in the overhead console that operate the sunroof. Manual-Open/Manual-Close: To open the sunroof press and hold the rear of the driver's side switch until the sunroof reaches the desired position. To close the sunroof, press and hold the front of the driver's side switch until the sunroof reaches the desired position. The sunshade will open automatically with the sunroof, but can also be opened manually. 2-77