2009 GMC Yukon Owner's Manual - Page 395

Electric Brake Control Wiring Provisions These wiring provisions are included with the vehicle as part of the trailer wiring package. These provisions are for an electric brake controller. The instrument panel contains blunt cut wires near the data link connector for the trailer brake controller. The harness contains the following wires: Trailer Recommendations Subtract the hitch loads from the Cargo Weight Rating (CWR). CWR is the maximum weight of the load the vehicle can carry. It does not include the weight of the people inside, but you can figure about 150 lbs. (68 kg) for each passenger. The total cargo load must not be more than the vehicles CWR. Weigh the vehicle with the trailer attached, so the GVWR or GAWR are not exceeded. If using a weight-distributing hitch, weigh the vehicle without the spring bars in place. The best performance is obtained by correctly spreading out the weight of the load and choosing the correct hitch and trailer brakes. For more information see Towing a Trailer on page 4-52. Dark Blue: Brake Signal to Trailer Connector Red/Black: Battery Light Blue/White: Brake Switch White: Ground It should be installed by your dealer/retailer or a qualified service center. If the vehicle is equipped with an ITBC, the blunt cuts exist, but are not connected further in the harness. If an aftermarket trailer brake controller is installed, the ITBC must be disconnected. Do not power both ITBC and aftermarket controllers to control the trailer brakes at the same time. 4-73