1999 Honda Odyssey Owner's Manual - Page 97

HomeLink Universal Transmitter 1. This step erases all previously learned codes. Perform this step before training the transmitter for the very first time. Press and hold the two outside buttons until the red light in the transmitter flashes (approximately 20 seconds). Release the buttons. 2. Hold the end of the garage door opener remote control 1 to 3 inches from the HomeLink transmitter. Make sure you are not blocking your view of the red light in the transmitter. 3. Select the transmitter button you want to train. 4. Press the button on the remote control and the button on the transmitter at the same time. Hold down both buttons. 5. The red light in the transmitter should begin flashing. It will flash slowly at first, then rapidly. 6. When the red light flashes rapidly, release both buttons. The transmitter should have learned the code from the remote control. 7. Test the transmitter button by pushing it. It should operate the garage door. 8. Repeat these steps to train the other two transmitter buttons to operate any other remotelycontrolled devices around your home (lighting, automatic gate, security system, etc.). Canadian Owners: The remote control you are training from may stop transmitting after two seconds. This is not long enough for the HomeLink transmitter to learn the code. Release and press the button on the remote control every two seconds until the transmitter has learned the code. If you are programming the transmitter to operate a garage door or gate, it is recommended that you unplug the motor for that device during programming. Repeatedly pressing the remote control button could burn out the motor. The HomeLink transmitter stores the code in a permanent memory. There should be no need to retrain the transmitter if your vehicle's battery goes dead or is disconnected. Instruments and Controls