2002 Honda Civic Owner's Manual - Page 245

Lights WEATHER SEAL BULB 5. Insert the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place and clip the end into the slot. 6. Install the rubber seal over the back of the headlight assembly. Make sure it is right side up; it is marked ''TOP.'' Replacing the Front Side Marker/ Turn Signal and Parking Light Bulb 1. If you are changing the bulb on the driver's side, start the engine, turn the steering wheel all the way to the right, and turn off the engine. If you are changing the bulb on the passenger's side, turn the steering wheel to the left. CONNECTOR HOLD-DOWN WIRE 2. Remove the electrical connector from the bulb by squeezing the connector on both sides to unlock the tab. Pull the connector straight off. 3. Remove the rubber weather seal by pulling on the tab. 4. Unclip the end of the hold-down wire from its slot. Pivot it out of the way and remove the bulb. 7. Push the electrical connector onto the tabs of the new bulb. Make sure it locks in place. Turn on the headlights to test the new bulb. 8. (Driver's side) Reinstall the power steering reservoir. 248 Maintenance