2009 Hummer H3 Owner's Manual - Page 115
2009 Hummer H3 Manual
Page 115 highlights
Features and Controls 2-49 Rear Storage Area The H3 has a rear storage area located on the passenger side of the cargo area. To open it, pull the two tabs out and open lid. To install the cover, place the loops on each corner of the cover on the four hooks in the rear of the vehicle. The cover should be stored securely when not in use. Convenience Net Use the convenience net, located in the rear, to store small loads as far forward as possible. The net should not be used to store heavy loads. Cargo Tie Downs There may be four cargo tie-downs that can be moved on the tracks located on the roof. To move, loosen the tie-down counterclockwise. Turn clockwise to tighten and lock in place. Cargo Cover (H3) Notice: Do not put items onto the cargo cover. The weight of the items could cause the attachment clips to break. The cargo cover could no longer be attached and used. The repairs would not be covered by the warranty. Never put anything on top of the cargo cover. The vehicle may have a cargo cover. It can be used to cover items in the rear of the vehicle. Cargo Management System (H3T) The vehicle comes with a cargo management system located in the bed of the vehicle. The system contains three rails located on the front and sides of the bed. The system has four adjustable cargo tie-downs, that can be placed on the upper and lower slides of the rail. To adjust a tie-down, pull the locator pin out and move the tie-down to another location making sure the locator pin lines up with a locator hole on the rail. The tie-down pin may not be installed correctly if the pin does not line up, turn it over and reinstall. The tie-down will not move when the pin is completely installed. The maximum load for each rail is 500 lbs (227 kg). The rails are notched at each end which allows the tie-downs to be removed and placed on another rail. To remove, pull the locator pin out and slide the tie-down to the end of the rail and pull back.