2009 Hummer H3x Owner's Manual - Page 125

Instrument Panel Have the bulbs replaced. If the bulb is not burned out, check the fuse. For bulb replacement, see Taillamps, Turn Signal, Stoplamps and Back-up Lamps (H3) on page 5-42 or Taillamps, Turn Signal, Stoplamps and Back-up Lamps (H3T) on page 5-42. For a blown fuse or circuit breaker, see Fuses and Circuit Breakers on page 5-91. Turn Signal On Chime If a turn signal is left on for more than 3/4 of a mile (1.2 km), a chime will sound at each flash of the turn signal and the message TURN SIGNAL will also appear in the DIC. To turn the chime and message off, move the turn signal lever to the off position. See "TURN SIGNAL" under DIC Warnings and Messages on page 3-37 DIC Warnings and Messages for more information. 3-7 Headlamp High/Low-Beam Changer 2 3 Headlamp High/Low Beam Changer: Push the turn signal/multifunction lever away from you to turn the high beams on. Pull the lever towards you to return to low beams. If the headlamps are in the automatic position or on low beam, the high-beam headlamps will turn on. They will stay on as long as the lever is held toward you. The high-beam indicator on the instrument panel cluster will come on. Release the lever to return to normal operation. Windshield Wipers The windshield wipers are controlled by turning the band with N on it. This indicator light turns on in the instrument panel cluster when the high beam headlamps are on. 8 (Mist): Flash-to-Pass This feature lets you use the high-beam headlamps to signal a driver in front of you that you want to pass. It works even if the headlamps are in the automatic position. To use it, pull the turn signal lever toward you, then release it. Turn to mist for a single wiping cycle. Hold it there until the wipers start. Then let go. The wipers will stop after one wipe. Hold the band on mist longer, if more wipes are needed. N (Delay): The wiper speed can be set for long or short delays between wipes. This can be very useful in light rain or snow. Turn the band to choose the delay time. The closer to the top of the lever, the shorter the delay.