2008 Infiniti FX35 Owner's Manual - Page 365
2008 Infiniti FX35 Manual
Page 365 highlights
INSTALLING FRONT LICENSE PLATE 1. Temporarily place the license plate 1 2 bracket k while aligning part k of 3 the front bumper with part k of the rear surface of the license plate bracket. 2. To determine where to drill the hole, mark along both sides of the mounting hole by using a felt-tip pen 4 k. 3. Remove the license plate bracket and connect the arcs to form ovals. Mark the point in the center of each oval. These are the pilot drilling locations. 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked 5 locations k . (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 6 5. Insert grommets k into the hole on the fascia. STI0407 Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the vinyl bag. License plate bracket J-nut x 2 Screw x 2 Screw grommet x 2 7 6. Insert a flat-blade screwdriver k into the grommet hole to turn the threaded 8 part of the grommet 90° k . 9 7. Insert a J-nut k into the license plate bracket before placing the license plate bracket on the fascia. Technical and consumer information 9-13