2008 Infiniti FX35 Owner's Manual - Page 45

straint. Not all child restraints fit in all types of vehicles. 10. Check that the retractor is in the ALR mode by trying to pull more seat belt out of the retractor. If you cannot pull any more belt webbing out of the retractor, the retractor is in the ALR mode. 11. Check to make sure the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 4 through 9. Front facing - step 12 12. If the child restraint is installed in the front passenger seat, turn the ignition switch to the ON position. The front passenger air bag status light should illuminate. If this light is not illuminated, see "Front passenger air bag and status light" in this section. Move the child restraint to another seating position. Have the system checked by an INFINITI dealer. After the child restraint is removed and the seat belt is fully retracted, the ALR mode (child restraint mode) is canceled. SSS0614 SSS0100 Rear-facing Follow these steps to install a rear-facing child restraint using the vehicle seat belt in the rear seat: 1. Adjust the seatback so that it is upright. Do not move the rear seatbacks with the child restraints attached to them. 2. Child restraints for infants must be used in the rear-facing direction and therefore must not be used in the front seat. Position the child restraint on the seat. Always follow the restraint Safety - Seats, seat belts and supplemental restraint system 1-31