2006 Jeep Grand Cherokee Owner Manual SRT8 - Page 115

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115 To Disable A Transmitter Linked to Memory 1. Turn the ignition switch to the OFF position and remove the key. 2. Press and release memory button number 1. The system will recall any memory settings stored in position 1. Wait for the system to complete the memory recall before continuing to step 3. 3. Press and release the memory SET (S) button located on the driver's door. 4. Within 5 seconds, press and release memory button 1 on the driver's door. 5. Within 5 seconds, press and release the "Unlock" button on the Remote Keyless Entry transmitter. To disable another transmitter linked to either memory position, repeat steps 1-5 for each transmitter. NOTE: Once programmed, all transmitters linked to memory can be easily enabled or disabled at one time. Refer to Remote Linked to Memory under ЉElectronic Vehicle Information Center (EVIC) - Customer Programmable FeaturesЉ in Section 4 for more information. Easy Entry/Exit Seat This feature provides automatic driver's seat positioning which will enhance driver mobility out of and into the vehicle. There are two possible Easy Exit and Easy Entry adjustments available: • The seat cushion will move rearward approximately 2.5 inches (60 mm) if the starting position of the seat is greater than or equal to 3.75 inches (90 mm) forward of the rear seat stop when the key is removed from the ignition switch. The seat will then move forward approximately 2.5 inches (60 mm) when the key is placed into the ignition and turned out of the LOCK position. 3